MKS-GEN V1.4 Integrated Controller Mainboard + 5pcs TMC2130 V1.0 Stepper Motor Driver Compatible Ramps1.4/Mega2560 R3 For 3D Printer

$76.99

In stock

MKS-GEN V1.4 Integrated Controller Mainboard + 5pcs TMC2130 V1.0 Stepper Motor Driver Compatible Ramps1.4/Mega2560 R3 For 3D Printer
MKS-GEN V1.4 Integrated Controller Mainboard + 5pcs TMC2130 V1.0 Stepper Motor Driver Compatible Ramps1.4/Mega2560 R3 For 3D Printer $76.99

Free shipping on all orders

  • 30 days easy returns
  • Tracking information available on all orders
Guaranteed Safe Checkout

Products Name:Product id:–>
MKS-GEN V1.4

Features:1. It gather 2560 and ramps1.4 on a same board, which solved the Ramps1.4 combination interface problem that easily out of order.
2. Can replace the motor driver, support 4988 drivers and 8825 drivers
3. Circuit board uses the high quality of 4 layer board,optimize heat dissipation;Ramp Is 2 layer board
4. Using special power supply chip, support the 12v-24v power input, solve the problem of Ramps voltage conversion of chip fever.
5. Accept 24V input, under the same system power can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating
6. The firmware can use open source firmware Marlin, configuration are exactly the same with ramps1.4 , can be directly replace ramps1.4 also
Can be connected directly to Ramps1.4, 2004 LCD control board and the LCD board (12864)
7. Provide three 5V output, three 12V-24V output interface.
TMC2130 Stepper Motor Driver
Features:1. The driver boards are hardware compatible with StepStick and Pololu A4988.
2. Two-phase stepper motor single-phase current 2A (peak 2.5A) motor operating currently adjustable
3. Support Step / DIR interface and SPI interface, two control methods
4. Combined with maximum efficiency and optimum motor torque without noise operation
5. High-precision sensorless motor load detection
6. To reduce energy consumption by 75%
Specification
Model
TMC2130  v1.0
Interface
Step/Dir
Configuration
CFG Pins
Native Microsteps*
Up to 1/256
MicroPlyer Microsteps
1/256
Logic Voltage VIO
3-5V
Motor Voltage VM
5.5-46V
Motor Phase Current
1.2A RMS, 2.5A Peak
VM always needed**
Yes
Internal V- Regulator**
Enabled
RDSon
>=0.5 Ohm
StealthChop (quiet)
Yes
Spread Cycle
Yes
CoolStep
Yes
StallGuard
Yes
Dcstep
Yes
Package Included:1x MKS Gen V1.4 board
1x 50cm USB cable
5x TMC2130 V1.0 Stepper Motor Driver
5x Heatsink
1x Screwdriver

12345678910