Product Name: MKS-GEN V1.4
Product ID: —
Features:
- Combines 2560 and ramps1.4 on a single board, solving the frequent interface problem of the Ramps1.4 combination.
- Allows for the replacement of the motor driver, compatible with both 4988 drivers and 8825 drivers.
- Utilizes a high-quality 4-layer circuit board for optimized heat dissipation, outperforming the 2-layer board of Ramp.
- Equipped with a special power supply chip that supports 12v-24v power input, effectively addressing the heat issue of the Ramps voltage conversion chip.
- Accepts 24V input, reducing the hotbed current to 1/4 under the same system power and thereby solving the heat problem of the hotbed MOS tube.
- It’s compatible with open-source firmware Marlin, with configurations identical to ramps1.4. It can directly replace ramps1.4, and it can also be connected directly to Ramps1.4, 2004 LCD control board, and the LCD board (12864).
- Offers three 5V outputs and three 12V-24V output interfaces.
TMC2130 Stepper Motor Driver Features:
- The driver boards are hardware-compatible with StepStick and Pololu A4988.
- Two-phase stepper motor with single-phase current 2A (peak 2.5A), with adjustable motor operating current.
- Supports Step / DIR interface and SPI interface, offering two methods of control.
- Delivers maximum efficiency and optimal motor torque operation without noise.
- High-precision sensorless motor load detection.
- Can reduce energy consumption by up to 75%.
Specification:
Model: TMC2130 v1.0
Interface: Step/Dir
Configuration: CFG Pins
Native Microsteps: Up to 1/256
MicroPlyer Microsteps: 1/256
Logic Voltage VIO: 3-5V
Motor Voltage VM: 5.5-46V
Motor Phase Current: 1.2A RMS, 2.5A Peak
VM always needed: Yes
Internal V- Regulator: Enabled
RDSon: >=0.5 Ohm
StealthChop (quiet): Yes
Spread Cycle: Yes
CoolStep: Yes
StallGuard: Yes
Dcstep: Yes
Package Included:
1x MKS Gen V1.4 board
1x 50cm USB cable
5x TMC2130 V1.0 Stepper Motor Driver
5x Heatsink
1x Screwdriver
Product Images: