Description
Bid goodbye to any capacitor problems with the MESR-100 AutoRanging ESR Low Ohm Circuit Capacitor Meter Tester!
Features
This small but powerful device offers a measuring range of 0.001 to 100.0R, with incredible support for IN-CIRCUIT testing. What sets it apart from the rest is its ability to use a 100 KHz sine wave to accurately measure the ESR value. This is precisely the same testing method that is used by leading capacitor manufacturers!
Understanding ESR of a capacitor
The ESR of a capacitor refers to the series resistor housed within a capacitor. We use 100kHz to eliminate the impedance 1/(2piF*C). What follows is a reduction in impedance and then we’re enabled to measure the true series resistor’s value. When an E-capacitor is found to have a higher ESR, it creates a large ripple as opposed to filtering noise. Generally, a large E-capacitor has more than 3 ohms.
Leveraging this concept, we’re able to determine if a capacitor is in good condition or if it’s bad/damaged. Because the ESR meter we use only applies less than 15mV DC or peak to peak on a ‘good’ capacitor, this tool can be used for in-circuit testing. The testing voltage is so low that it won’t turn on the semiconductors in a circuit under testing.
In cases of repairing a TV, an LCD, an Audio board and similar equipment, in-circuit testing will allow us to determine if a capacitor is functioning optimally or not.
Specifications
1. Accuracy
We achieve an accuracy of up to 1% (details above)
2. Exceptional Resolution
Our device delivers 4-digit readings or 0.001Ohm @ 1 ohm range
3. Measuring Voltage
4. Clamping Voltage
An open voltage setting of approximately 0.15V is supported
5. Power
It runs on 2X AA 1.5V batteries
6. External Power Supply
5V micro USB
7. Operating Current
0.02A
8. Battery Life
Greater than 80 Hours
What’s in the box?
Your MESR-100 Circuit Capacitor Meter comes with:
1 x MESR-100 Circuit Capacitor Meter
2 x Test Clips
1 x English Manual
Details in Pictures
rnrn
