Product Description:
The RAMPS 1.6 is a refined version of the Ramps 1.4 and Ramps 1.5. While keeping a similar structure to the Ramps 1.5, the RAMPS 1.6 introduces new 2pin connectors that are easier to engage and less susceptible to burn out. Moreover, it is equipped with an improved heat-sink over the MOS tube to enhance heat dissipation. The RAMPS 1.6 possesses a greater power capacity compared to the 1.5 variant, with a maximum power output of 270W, whilst the 1.5 can only accommodate up to 200W.
Features:
- Four-layer board design.
- Extendable to LCD and other components.
- Comes with heater and fan MOSFET outputs with three thermistor interfaces.
- Possesses a 5A additional security and component protection fusion.
- The heated bed has an additional 11A fuse.
- Compatible with 5 Pololu stepper drive boards.
- The design allows for easy replacement or removal of the Pololu plate pin socket for future iterations.
- Provisioned with I2C and SPI pins for future extensions.
- Gold-plated servo connectors with a 3A rated current suitable for binding limit stops, motors, and LED lights.
- LED indicator lights up when the heater is operational. The device can be connected to two motors for Z Prusa Mendel.
Specifications:
Size: 101.5 * 60.5mm
Supported Motor Drivers: A4988, DRV8825 and others; can support five motor drivers simultaneously.
Input Voltage: 12V
Power: 200W
Patch MOS Tube: B55NF06
Notes:
- If the TMC2100 driver is plugged in, a short-circuit cap is not needed under the driver.
- Among all drivers, the TMC2130 is the quietest when compared with RAMPS 1.5 and 1.6.
Package Inclusion:
1x RAMPS 1.6 Control Board
1x Heat Sink
Several Jumper Caps
