Product includes:
- 1 MKS GEN L motherboard
- 1 USB cable
- 1 MOS MINI module
- 2 Power cord lines
- 1 12864 display
- 6 limit switches with cables
- 5 A4988 drives (red/green sent randomly)
- 5 Heat sinks
Features of MKS GEN L Mainboard:
- Combines 2560 and Rampsl.4 onto a single PCB for straightforward wiring and increased stability.
- Built with a superior quality 4-layer PCB.
- Utilizes Marlin firmware, providing the same configuration approach as Rampsl.4, enabling it to replace Rampsl.4 directly.
- Employs a special power chip that supports 12V-24V.
- Supports a range of stepper drivers including 4988,8825,TMC2208, and TMC2100.
- Compatible with LCD2004, LCD12864, MKS TFT24/28/32/35/70.
- Accepts 24V input, reducing the heated bed current to 1/4, efficiently solving the Mosfet heat problem.
- Allows the connection of external large stepper drivers.
- Retains the Servos, AUX-1, and AUX-2 interface of Ramps 1.4, providing three 5V output and three 12V output interfaces.
Features of the LCD 12864:
- The intelligent controller includes an SD card reader, rotary encoders, and a 12864LCD display. Connects easily to your RAMPS 1.4 board using the included “smart adapter”.
- The board enables the execution of all operations such as calibration, axis movement using only the rotary encoder intelligent controller.
- Supports 3D design print without a computer, using the G code design stored on the SD card.
Features of the limit switch:
- The package includes a tap the travel limit switch that is compact in size and easy to install. It includes a built-in trigger indicator and offers plug and play functionality.
Features of the MOS MINI Module:
- High power expansion module designed for 3d printer hot beds.
- Provides powerful heat dissipation, resolving excessive power and current load issue caused by the hot bed.
- Contains an excellent performance MOS tube with a nominal maximum current of 280A.
- Includes a large heat sink, allowing maximum current up to 30A. (Not exceed 30A during use)
- Allows direct use of the hot bed output signal control of Ramp1.4 and MKS series motherboards.
- Supports 5-24V digital signal control.
Features of A4988 Stepper Motor Driver:
- Suitable for driving stepper motors below 8V-35V 2A.
- Offers five different stepping modes: full, half, 1/4, 1/8, and 1/16.
- Comes with an adjustable potentiometer to control the maximum current output for a higher step rate.
- Includes automatic current attenuation mode detection/selection.
- Equipped with overheating shutdown circuit, under voltage lockout, and cross current protection.
- Features a grounding short circuit protection and load short circuit protection.
Images of the product can be seen below.